Vogelzang International SR57E Benutzerhandbuch

Seite von 12
Page 2 
/ SR57E
 
VGZ-004 / 20110524.0
14. Ashes  should  not  be  allowed  to  accumulate 
higher than the side of the ash pan. Dispose of 
ashes in a metal container with a tight fitting 
lid.  Other  waste  shall  not  be  placed  in  this 
container. Keep the closed container on a non-
combustible floor or on the ground, well away 
from all combustible materials. Keep the ashes 
in the closed container until all cinders have 
thoroughly cooled. The ashes may be buried in 
the ground or picked up by a refuse collector.
15. To prevent burns, always wear protective cloth-
ing, leather hearth gloves and eye protection, 
while tending the fire.
16. While in operation, keep the feed door closed 
at all times except while tending the fire. 
17. Do  not  over  fire  the  stove.  Over  firing  will  
occur  if  the  feed  door  is  left  open  during  
operation.  Such  actions  will  result  in  very  
dangerous operating conditions.
NOTE:  A  PROFESSIONAL,  LICENSED  HEAT-
ING  AND  COOLING  CONTRACTOR  SHOULD   
BE  CONSULTED  IF YOU  HAVE  qUESTIONS   
REGARDING THE  INSTALLATION  OF THIS   
SOLID FUEL BURNING APPLIANCE.
SAFETY INSTRUCTIONS continued…
ASSEmblY INSTRUCTIONS
 
 
tools
 
required
CAUTION: STOVE IS HEAVY. mAkE SURE YOU 
HAVE  ADEqUATE  HELP  AND  USE  PROPER 
LIFTING TECHNIqUES wHENEVER  mOVING 
STOVE.
Refer  to  diagram  and  parts  lists  at  back  of  this 
manual.
1.  Uncrate the stove and remove cardboard pack-
ing and protective poly bag. (Save cardboard 
for further assembly.)
2.  Remove  parts  from  inside  of  stove.  Parts  
include: four lids (#1), three lid supports (#4 
& #5), one ash door (#14), one lid lifter (#16),  
four  legs  (#15),  hardware  pack  (#17),  and 
materials
 
required
 (NOTE: The following items are NOT included with your stove)
Spring Handle (#12) and draft damper (#18).
3.  Place  flattened  carton  on  floor  and  carefully 
turn stove over onto carton.
4.  Attach  the  legs  to  base  of  stove  with  stove 
bolts.
5.  Carefully  lift  stove  upright  and  place  in  de-
sired  location  (see  following  instructions  for  
properly locating stove).
6.  Place lid supports and four lids in position on 
stove top.
7.  Lower ash door into position.
8.  Install draft damper into stove pipe.
1/8” dia. Drill Bit  
(sheet metal screws)
Screwdrivers 
(blade and phillips types)
13mm Nut Driver or Ratchet  
with 13mm Socket (for 13mm  
Hex Nuts)
13mm Nut Driver or  
Ratchet with 13mm Socket 
(for Stove Bolts)
Safety Glasses
Hearth Gloves
Pencil
6 foot Folding Rule or  
Tape measure
Tin Snips
Drill: Hand or Electric
Flooring Protection: 56” x 59” 
as specified (see page 3)
Chimney Connection: 6” black 
steel  (24  ga.  min.)  straight  or  
elbow (as required)
1/2” Sheet metal Screws
Chimney: Existing 6” Lined ma-
sonry Chimney or 6” Inside Dia. 
listed Type HT chimney.
Furnace Cement (manufacturer 
recommends Rutland Code 78 
or equivalent)
10. The  paint  used  on  your  stove  may  give  off 
smoke and/or odor during the first fires. This 
may occur during the first 12 to 15 fires until 
the paint has cured. After the paint has cured 
this  will  end  and  not  reoccur.  Persons  with 
lung  conditions  or  owners  of  susceptible  
domestic  pets  (such  as  birds)  should  take  
prudent precautions. Open windows and doors 
as needed to clear smoke and odor. If the stove 
is overfired, paint discoloration will occur.
11. This  stove  has  a  painted  surface  which  is  
durable  but  it  will  not  stand  rough  handling 
or abuse. When installing your stove, use care 
in handling. Clean with soap and warm water 
when stove is not hot. Do not use any acids  
or scouring soap, as these solvents wear and 
dull the finish.
12. While  stove  is  in  operation,  all  persons,  
especially young children should be alerted to 
the  hazards  from  high  surface  temperatures. 
Keep  away  from  a  hot  stove  to  avoid  burns 
or clothing ignition. During operation, small  
children should be carefully supervised when 
they are in the same room as the stove.
13. Keep  stove  area  clear  and  free  from  all  
combustible  materials,  gasoline,  and  other 
flammable vapors and liquids.