Toshiba Tortilla Maker HV6FS-MLD Installationsanweisungen
Page 10
RECEIVING, INSPECTION AND HANDLING
RECEIVING AND UNPACKING
The circuit breaker units are subjected to factory
production testing prior to being packed and
shipped.
ACCEPTANCE INSPECTION
Confirm that the circuit breaker and cell units are
complete, correct as specified and undamaged
from shipment and handling.
Upon receipt of the equipment, do the following:
1) Make an immediate inspection for damage
that might have occurred during shipment. If
damage is discovered, it should be noted
with the carrier prior to accepting the
shipment, if possible.
damage is discovered, it should be noted
with the carrier prior to accepting the
shipment, if possible.
2) Carefully unpack the equipment sufficiently to
check for missing parts or concealed
damage.
damage.
3) Check for the presence of accessories that
are shipped with the circuit breaker and cell:
- Charging Handle (Fig. 5)
- B9 Grease (Fig. 6)
- Control Wire Harness (Fig. 7)
- B9 Grease (Fig. 6)
- Control Wire Harness (Fig. 7)
3) Keep the circuit breaker and cell upright.
Never lay the circuit
breaker or cell on its side
or upside down. This may
cause damage.
breaker or cell on its side
or upside down. This may
cause damage.
4) File a claim with the carrier for any damaged
or missing items and immediately notify the
nearest Toshiba representative.
nearest Toshiba representative.
Do not install or energize
equipment that has been
damaged. Damaged
equipment can fail during
operation, resulting in fire
and explosion.
equipment that has been
damaged. Damaged
equipment can fail during
operation, resulting in fire
and explosion.
Fig. 5 Charging Handle
Fig. 6 B9 Grease
Fig. 7 Control Wire Harness
CAUTION
WARNING
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net