Leibherr USA Refrigerators and freezers for integrated use, door-on-door HRB 1110 HF 851 Benutzerhandbuch
6.1 Assembling the appliance
Fig. 11
Unit depth less than 21 3/4 in. (553 mm) Detach the
spacers from the rear of the appliance so that you can slide
the appliance completely into the recess. Removing the
spacers may cause the appliance to use more energy, as
this reduces the ventilation cross-section.
Fig. 12
u
Undo the screw
Fig. 12 (50)
and detach the spacer
Fig. 12 (51)
.
All appliances:
u
Remove the power cord from the back of the
appliance. Also remove the cable holder, otherwise
there will be vibration noise!
u
Position the power cord using
a piece of string so that the
appliance can easily be
connected to the electricity
supply after it has been built-in.
Fig. 13
For appliances with a water filter:*
u
Remove the connector
Fig. 14 (52)
from the hose
ends: Press the dark gray
clip
Fig. 14 (53)
into the
connector while at the same
time pulling out the hose
Fig. 14 (54)
.*
Fig. 14
*
u
Connect the supplied extension hoses to the appliance
hoses: Slide the appliance hoses into the connectors as
far as they will go (approx. 21/32 '' (17 mm)).*
u
Position the hoses using a piece of
string so that they can be
connected to the water filter later
*
Appliances with a plumbed-in connection for the
IceMaker:
u
Connect the IceMaker .*
All appliances:
u
Push the appliance 3/4 of the way into the recess.
u
Remove covers
Fig. 11 (4,6,7)
.
u
Screw
Fig. 15 (11)
the
equalizer trim
Fig. 15 (24)
onto the top of the
appliance through the
oblong holes.
Fig. 15
u
Fasten a pair of
mounting
brackets
Fig. 16 (12)
into the pre-
bored holes in the
appliance door with a
hex
head
screw
Fig. 16 (13)
.
Fig. 16
For large or divided unit doors:
u
Fit a 2nd pair of mounting brackets
Fig. 28 (12)
.
u
Use the holes pre-drilled in handle area of
the appliance door for this purpose.
With 5/8 '' (16 mm) thick
unit walls:
u
Clip spacer
Fig. 17 (14)
and
spacer
Fig. 11 (15)
onto the
hinge.
Fig. 17
u
Place
the
covers
Fig. 18 (16)
top and bottom
onto
the
mounting
brackets
Fig. 18 (17)
.
u
Fasten the mounting
brackets
Fig. 18 (17)
on top
with screws
Fig. 18 (19)
and
on the bottom with
Screws
Fig. 11 (19)
such
that the bracket still has a
slight bit of play to the left
and right.
Fig. 18
Installation
10