Thermador PRG366JG Installationsanweisungen
English 16
Step 8: Backguard Installation
(optional)
Installation methods will vary upon need. Before you begin read these instructions carefully. Observe all local codes and
ordinances.
ordinances.
Backsplash Installation
(PA [30,36, 48] JBS)
•
The backsplash must be installed prior to installing an
overhead hood given that the hood shell covers the top
mounting screws of the backsplash.
overhead hood given that the hood shell covers the top
mounting screws of the backsplash.
•
To protect against scratches, leave protective film on
backsplash until after installation is complete.
backsplash until after installation is complete.
•
If range is already installed, refer to the manufacturer’s
instructions to disconnect gas and power supplies.
Move range forward to gain access to rear of unit.
instructions to disconnect gas and power supplies.
Move range forward to gain access to rear of unit.
1.
Locate and lightly mark wall studs.
•
Wall studs are usually installed with a 16” or 24”
(406mm or 1372mm) space on center.
(406mm or 1372mm) space on center.
2.
The height of the hood will determine the height of the
top edge of the backsplash. The backsplash should be
mounted so that the bottom rear edge of the hood
overlaps the backsplash 1½” (38mm).
top edge of the backsplash. The backsplash should be
mounted so that the bottom rear edge of the hood
overlaps the backsplash 1½” (38mm).
3.
Per each wall stud, use (2) of the provided screws to
secure both the top and bottom of the backsplash (see
Figure 14).
secure both the top and bottom of the backsplash (see
Figure 14).
•
Due to variable wall stud widths and varying
backsplash widths, in some cases only one wall
stud may be found at the mounting location.
backsplash widths, in some cases only one wall
stud may be found at the mounting location.
4.
Remove protective plastic.
Parts Included
Tools Needed
(10) 1” (25.4mm)
screws
screws
Phillips screwdriver or
drill
drill
(1) Backsplash
Tape measure
(1) Installation Guide
Pencil
WARNING:
To reduce the risk of fire or injury to persons, check to
make sure all packaging has been removed from
accessory devices before use.
make sure all packaging has been removed from
accessory devices before use.
F
IGURE
14: B
ACKSPLASH
I
NSTALLATION
Wall Studs
30”, 36”, 48”
(760mm, 913mm, 1218mm)
4
2
”
(1
0
7
0
mm)
Space screws evenly
across top & bottom