Thermador PRG366JG Installationsanweisungen
English 6
F
IGURE
2: I
NSTALLATION
C
LEARANCES WITH
H
IGH SHELF OR
L
OW
B
ACKGUARD
F
IGURE
3: I
NSTALLATION
C
LEARANCES WITH
I
NCLUDED
F
LUSH
I
SLAND
T
RIM
Combustible Materials
48 ¾” (1238mm)
25
⅛
” (638mm)
High Shelf
12” (305mm)
materials
36” (914mm) Min
.
2¾” (70m)
36 ¾” Max (933mm)
35
⅞
” Min (911mm)
Low Backguard
maximum
recess depth
Combustible Back Wall
to combustible
26
⅞
” (683
mm)
29
⅛
” (740mm)
31
¼
” (794mm)
21
1
/
8
” (537mm)
9”
(229mm)
as defined in the “National Fuel Gas
Code” (ANSI Z223.1, Current Edition).
Clearances from non-combustible materi-
als are not part of the ANSI Z21.1 scope
and are not certified by CSA. Clearances
of less than 12” (305 mm) must be
approved by the local codes and/or by the
local authority having jurisdiction.
Clearances from non-combustible materi-
als are not part of the ANSI Z21.1 scope
and are not certified by CSA. Clearances
of less than 12” (305 mm) must be
approved by the local codes and/or by the
local authority having jurisdiction.
materials
36” (914mm) min
to combustible
Cantilever
12” (305mm) min
to combustible
to combustible
36 ¾” Max (933mm)
35
⅞
” Min (911mm)
Combustible Materials
Flush Island Trim
Note: For Flush Island
Trim installations,
counter surface should
have a cantilever edge
meeting the back section
Trim installations,
counter surface should
have a cantilever edge
meeting the back section
of the Flush Island Trim
accessory.
Note: If an inner wall is
used under the cantilever
counter top, there should
be a 1/8” (3mm) gap from
the rear of the range to the
inner wall.
used under the cantilever
counter top, there should
be a 1/8” (3mm) gap from
the rear of the range to the
inner wall.
as defined in the “National
Fuel Gas Code” (ANSI Z223.1,
Current Edition). Clearances
from non-combustible materials
are not part of the ANSI Z21.1
scope and are not certified by
CSA. Clearances of less than
12” (305 mm) must be
approved by the local codes
and/or by the local authority
having jurisdiction.
Current Edition). Clearances
from non-combustible materials
are not part of the ANSI Z21.1
scope and are not certified by
CSA. Clearances of less than
12” (305 mm) must be
approved by the local codes
and/or by the local authority
having jurisdiction.
surface with Flush
Island Trim
Island Trim