Meyer Sound MG-3D/M Benutzerhandbuch
mg-3d/m multipurpose grid and accessories
PN: 05.132.036.01 B2
Page 27 of 32
Meyer Sound Laboratories Inc.
www.meyersound.com
www.meyersound.com
T: +1 510 486.1166
F: +1 510 486.8356
F: +1 510 486.8356
pbf-milo pull-back frame
The up and down tilt of the MG-3D/M multipurpose grid and the complete MILO array hung underneath can be ad-
justed using chain motors, or differing lengths of steel cables or chain lengths. The rigging connections between MILO
loudspeakers using the MFAL-MILO front AlignaLinks and MRAL-MILO rear AlignaLinks are rigid, and in most applica-
tions array tilt can be achieved by adjusting the angle of the MG-3D/M grid. For applications where you need an ex-
treme tilt and motor adjustments alone are not enough, the PBF-MILO pull-back frame can be attached to the lowest
MILO cabinet in the array. The MTB-2D/M kit and an extra motor or lifting device are required for this configuration.
justed using chain motors, or differing lengths of steel cables or chain lengths. The rigging connections between MILO
loudspeakers using the MFAL-MILO front AlignaLinks and MRAL-MILO rear AlignaLinks are rigid, and in most applica-
tions array tilt can be achieved by adjusting the angle of the MG-3D/M grid. For applications where you need an ex-
treme tilt and motor adjustments alone are not enough, the PBF-MILO pull-back frame can be attached to the lowest
MILO cabinet in the array. The MTB-2D/M kit and an extra motor or lifting device are required for this configuration.
caution:
when using the PBF-MILO pull-back frame, the total weight of the array should always be
calculated and be within specifications before flying the array. Do not exceed the MTG-3D/M grid load
ratings listed in Chapters 2 and 3 of this guide.
note:
If a severe up tilt is needed, the MTB-2D bars can be reversed, allowing you to install the PBF-
MILO pull-back frame to the front of the array.
note:
Use the array rigging calculator to compute load and center-of-gravity data. Visit www.
meyersound.com/arraycalculator to find out how to download the calculator.
list of contents: pbf-milo pull-back frame (40.132.034.01)
Qty
part number
description
a
1
40.132.034.01
PBF-MILO Pull-Back Frame
note:
The approxi-
mate combined weight
of the PBF-MILO pull-back
frame and MTB-2D transition
kit is 42 lbs (19.41 kg).
frame and MTB-2D transition
kit is 42 lbs (19.41 kg).
a