Avaya 03-300430 User Manual

2000

ABRT

Response to the test was not received within the allowable time period. 

This may be due to hyperactivity. Error type 1538 in the error log 

indicates hyperactivity. The hyperactive circuit pack is out of service and 

one or more of the following symptoms may be exhibited.

●

The DS1-BD tests (such as test 138 and test 139) are aborting 
with error code 2000.

●

The tests run on the ports of this circuit pack are returning a no 
board result.

●

A busyout or a release command has no affect on the test 

results.

●

A list config command shows that the circuit pack and the 

ports are properly installed.

When hyperactivity occurs, the circuit pack is isolated from the system, 

and all of its trunks are placed into the out-of-service state. The system 

will try to restore the circuit pack within 15 minutes. When no faults are 

detected for 15 minutes, the DS1 interface circuit pack is restored to 

normal operation. Every DS1 interface trunk is then returned to the 

in-service state. Hyperactivity is often caused by the associated facility. In 

such a case, faults (such as slips, misframes, or blue alarms) would be 

entered in the error log. In addition, many hardware errors would be 

logged against the associated trunk circuits. If the facility is OK and the 

error occurs again after 15 minutes, escalate this problem.

1313

FAIL

The TN767E DS1 circuit pack could not deactivate the loop back 
through the Customer loop-back jack.

1. Retry test ds1-loop location end-loopback/span-test 

at 1-minute intervals up to 5 times.

1314

FAIL

The TN767E DS1 circuit pack could not deactivate the loop back 
through the far-end CSU.

1. Make sure that the far-end DS1 is installed if the far-end CSU is a 

120A CSU module/T1 sync splitter.

2. Retry test ds1-loop location end-loopback/span-test 

at 1-minute intervals up to 5 times.

 

PASS

The active long-duration loop-back or span test on the TN767E circuit 

pack was successfully deactivated.

 2 of 3