Avaya 03-300430 User Manual

2500

ABRT

Internal system error

1. Retry the command at 1-minute intervals up to 3 times.

FAIL

Near-end external loop back failed. A problem exists in the path of the loop 
back.

1. If the test is executed as a part of an error analysis, then return back to 

the related section.

2. Enter display errors and follow the associated repair procedures 

for any on-board DS1C-BD errors.

3. If the loop-back point is LB 1, replace connectors and cables between 

the DS1 converter A and the CSU A. If the loop-back point is LB 2, 
replace CSU A. Also see the repair procedure for Error Type #1025 
(loss of frame alignment).

4. If the test still fails, replace DS1 converter A circuit pack.

Any

PASS

Transmission through the path of the loop back is successful. TN1654 DS1 

facilities will display the round trip delay time in milliseconds in the Error 

Code field. The round trip delay time is defined as the length of time in 

milliseconds it takes for the firmware to receive the test pattern after it has 

been sent. This measurement is taken on the last DS1 channel tested.

 2 of 2