Avaya 03-300430 User Manual

3585

FAIL

Aux Data = 2. The board is reporting different options than what is 

administered. Software tried to correct the options but the board did not 

take the option update. It could be argued that this is a false alarm, 

especially if the link is operating correctly with no observable degradation of 

service. This capability (Test 1511) started with release R011i.03 1.531.0.

Note:

Do not immediately replace the board for this fault. There is 
a mismatch between what is programmed in the board and 
administration on Communication Manager. 

Follow these steps to attempt to resolve the problem. 

1. Use the command steps listed below to administer the ethernet 

options to their desired values.
a) Enter get ethernet-options location to determine current 

settings, both administered and actual.
b) Enter change ip-interface location (Enable Ethernet Port 

field to n) to turn off the interface. Submit the command to disable the 
interface.
c) Enter change ip-interface location  change the Ethernet 

Options fields as required. Submit the form.
d) Enter change ip-interface location  (Enable Ethernet 

Port field to y) to turn on the interface. Submit the command. to 
enable the interface.
e) Enter get ethernet-options location to verify that Ethernet 

options are the same in administration and on the board.

2. If the board values and administration values still do not match repeat 

the actions from step 

 above one time. 

3. Set the administration values to the actual values that the board is 

reporting. Test the board using the test board location 

command. If the test still fails replace the board. 

4. If service is normal and the alarm is causing concern, disable the test 

and escalate the problem. 

 3 of 3