Avaya 03-300430 User Manual

1394

ABRT

The EI circuit pack is out of service and the test cannot be run. This 
condition is due to a change in the EI circuit pack’s ability to 
communicate with the EI or SNI circuit pack on the other end of the 
fiber.

1. Run Test #237, and check the Error Log for EXP-INTF Error Type 

1281. If Error Type 1281 is present or if Test #237 fails, see repair 
procedures for Test #237, in 

1395

ABRT

This test cannot be run on an EI circuit pack if it is part of the B-side 
PNC and duplicated PNC is not enabled.

1. If this test needs to run on this EI circuit pack, use change 

system-parameters duplication to enable PNC.

2. Use set pnc lock to prevent the system from doing a PNC 

interchange.

3. Repeat this test.

1413

ABRT

This test requires the use of a Tone-Clock circuit pack in each of the 
PNs used in this test. This abort code indicates that there are none of 
these circuit packs located in one of the PNs.

1. Verify that there is a Tone-Clock circuit pack in the PN where the 

EI circuit pack under test resides.

2. In a Direct Connect configuration, verify that there is a Tone-Clock 

circuit pack in the PN where the neighbor EIEI circuit pack circuit 
pack resides.

3. In a Center Stage Switch configuration, verify that there is at least 

one other PN, besides the PN where the EI circuit pack under test 
resides, with a Tone-Clock circuit pack.

1414

ABRT

This test requires the use of an active Tone-Clock circuit pack in each 
of the PNs used in this test that does not have a MAJOR or MINOR 
alarm logged against it. This abort code indicates that the active 
Tone-Clock circuit pack in one of the PNs being used for the test has a 
MAJOR or MINOR alarm logged against it.

1. Enter display alarms and resolve every TONE-BD and 

TONE-PT alarm.

 3 of 5