Avaya 03-300430 User Manual

1018

ABRT

Test disabled by administration. This only applies to analog stations. The 
default for this field is y, so you may want to determine why it was turned 
off on this station.

1. To enable the test for the particular analog station being tested, enter 

change station extension and set the Test field on the Station 

screen to y.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2020

ABRT

The test did not run due to an already existing error on the specific port or 
a more general circuit pack error.

1. Examine Error Log for existing errors against this port or the circuit 

pack and attempt to diagnose the already existing error.

2100

ABRT

System resources required to run this test are not available. This could be 
due to a failure to seize the port.

1. Retry the command at 1-minute intervals up to 5 times.

Any

FAIL

This test can fail due to on-board or off-board problems. Off-board 
problems of concern include EXP-PN, EXP-INTF, or RMC-ENV faults, 
TDM-BUS faults, and faults associated with the tone detectors/tone 
generators. Clear every off-board problem before replacing the board. 
Keep in mind that a TDM-BUS problem is usually the result of a faulty 
board connected to the backplane or bent pins on the backplane.

1. Resolve any EXP-PN, EXP-INTF, or RMC-ENV errors.

2. Resolve any TDM-BUS errors.

3. Resolve any TONE-BD and/or TONE-PT errors.

4. Test the board when the faults from steps 1, 2, and 3 are cleared. 

Replace the board only if the test fails.

PASS

The port uses its allocated time slots correctly. Investigate user-reported 

troubles on this port using other port tests and by examining station, trunk, 

or external wiring.

 3 of 4