Avaya 03-300430 User Manual

The Translation Update Test sends the circuit-pack-level information specified by System 
Administration to the MM710 Interface Media Module. Translation includes the following data 
administered for a MM710 Interface Media Module (see output of display ds1 location 

command): DS1 Link Length between two DS1 endpoints, Synchronization Source Control, All 
Zero Suppression, Framing Mode, Signaling Mode, Time Slot Number of 697-Hz Tone, Time 
Slot Number of 700-Hz Tone, etc.

 

ABRT

Internal system error

1. Retry the command at 1-minute interval s a maximum of 5 times.

 

FAIL

Internal system software error.

1. Enter the display ds1 location command to verify the MM710 

Interface Media Module translation.

 

PASS

Translation data has been downloaded to the MM710 Interface Media 

Module successfully.

Any

NO

BOARD

The test could not relate the internal ID to the port (no board). This could 
be due to incorrect translations, no board is inserted, an incorrect board 
is inserted, or an insane board is inserted.

1. Ensure that the board translations are correct. Execute the add ds1 

location command to administer the MM710 interface if it is not 

already administered.

2. If the board was already administered correctly, check the error log to 

determine whether the board is hyperactive. If this is the case, the 
board is shut down. Reseating the board will re-initialize the board.

3. If the board was found to be correctly inserted in step 1, then enter 

the busyout board location command.

4. Enter the reset board location command.
5. Enter the release board location command.
6. Enter the test board location long command. 

This should re-establish the linkage between the internal ID and the port.