Avaya 03-300430 User Manual

The ports on the Maintenance/Test circuit pack continually run self-tests, whenever the port is 
idle. The Angel uses a counter so that the Background Maintenance Failure message is only 
sent uplink once. Many circuit packs have counters in the Angel firmware. These counters are 
used so that Control Channel Message Set (CCMS) messages are not continuously sent uplink. 
Using this method, the message will be sent once, when the counter reaches some preset 
threshold, and then not sent again until the counter is cleared. This test is used to clear the 

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 3 times.

7

FAIL

Conference test failed on the primary information channel.

1. Run the circuit pack tests to check the Tone-Clock (TONE-BD) circuit 

pack and the Tone Detector circuit pack using test board 
location.

2. Resolve any problems that are detected on the Tone-Clock 

(TONE-BD) circuit pack or Tone Detector circuit pack. See the section 
on Tone Generator circuit pack.

3. If the Tone-Clock and Tone Detector circuit packs are functioning 

properly, and the test still fails, replace the Maintenance/Test circuit 
pack.

14

FAIL

The primary information channel is not transmitting properly. User may not 
notice any interruption in service or may not be able to use this port.

1. Run the circuit pack tests to check the Tone Generator circuit pack and 

the Tone Detector circuit pack using test board location.

2. Resolve any problems that are detected on the Tone Generator circuit 

pack or Tone Detector circuit pack. See the section on Tone Generator 
circuit pack.

3. If the Tone Generator and Tone Detector circuit packs are functioning 

properly, and the test still fails, replace the Maintenance/Test circuit 
pack.

PASS

The Maintenance/Test analog port analog trunk testing capability is 

operating correctly.

 3 of 3