Avaya 03-300430 User Manual

counter, so that if the port continues to fail during or after Communication Manager demands 
testing, the Angel will send a message to indicate that fact.
This test is only used to send a message to the Angel on the Maintenance/Test circuit pack. 
Therefore, this test should never abort or fail.

This test ensures that the Maintenance/Test analog port maintenance software and call 
processing agree on the on-/off-hook status of the Maintenance/Test analog port.

PASS

The message to clear the Maintenance/Test circuit pack’s counter for 

Background Maintenance Failures has been sent.

1

ABRT

Switch hook audit timed out. No response was received from the circuit 
pack for information about the switch hook state.

1. Retry the command at 1-minute intervals up to 3 times.

2. If the test continues to abort, replace the circuit pack and repeat the 

test.

2100

ABRT

System resources required to run this test are not available.

1. Retry the command at 1-minute intervals up to 3 times.

Any

FAIL

Internal system error

1. Retry the command at 1-minute intervals up to 3 times.

2. If the test continues to fail reset the circuit pack using busyout 

board location, reset board location, and release 
board location.

3. Retry the command at 1-minute intervals up to 3 times.

PASS

Call processing and Maintenance/Test analog port maintenance software 

agree on the Maintenance/Test analog port hook state.