Avaya 03-300430 User Manual

One or more Network Processing Elements (NPEs) reside on each circuit pack with a TDM-bus 
interface. (The TN464 UDS1 circuit pack has one SCOTCH-NPE chip instead of several NPE 
chips). The NPE controls port connectivity and gain, and provides conferencing functions on a 
per-port basis. The Conference Circuit test verifies that the NPE channel for the port being 
tested can correctly perform the conferencing function. The NPE is instructed to listen to several 
different tones and conference the tones together. The resulting signal is then measured by a 
Tone Detector port. If the level of the tone is within a certain range, the test passes.

0

NO

BOARD

The test could not relate the internal ID to the port (no board). This could 
be due to incorrect translations, no board is inserted, an incorrect board 
is inserted, or an insane board is inserted.

1. Check to ensure that the board translations are correct. Use list 

config, and resolve any problems that are found.

2. If the board was found to be inserted correctly, enter busyout 

board location.

3. Enter the reset board location command.
4. Enter the release board location command.
5. Enter test board location long.

This should re-establish the linkage between the internal ID and the 
port. If not, ensure that there is a valid board inserted.

 4 of 4

ABRT

System resources required for this test are not available.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

Could not seize the port for testing. The port may be in use on a valid call. 

Use status station or status trunk to determine when the port is 

available for testing.

 1 of 5