Avaya 03-300430 User Manual

1002

ABRT

The test was aborted because the system could not allocate time slots 
for the test. The system might be under heavy traffic conditions, or it 
might have time slots out of service due to TDM-BUS errors. Use 
status health to determine if the system is experiencing heavy 

traffic.

1. If the system has no TDM-BUS errors, is not handling heavy traffic, 

and the port status is idle, retry the command at 1-minute intervals 
up to 5 times.

1003

ABRT

The system could not allocate a tone receiver for the test. The system 
may be oversized for the number of tone detectors present or some of 
the tone detectors may be out of service. Enter list measurements 
tone-receiver to display basic information about the system's tone 

receivers.

1. Resolve any TTR-LEV errors.

2. Resolve any TONE-PT errors.

3. If neither condition exists, retry the test at 1-minute intervals up to 5 

times.

1004

ABRT

The port has been seized by a user for a valid call. Use status 
station or status trunk to determine when the port is available for 

testing.

1. Retry the command at 1-minute intervals up to 5 times.

1018

ABRT

The test was disabled by translation.

1. You may want to determine why the test has been disabled before 

you enable it.

2. To enable the test for the particular analog station being tested, enter 

change station extension, and set the Test field on the 

Station screen to y.

1020

ABRT

The test did not run due to an already existing error on the specific port 
or due to a more general error on the circuit pack.

1. Examine the error log for existing errors against this port or the circuit 

pack and attempt to diagnose the already existing error. (Error code 
1793 indicates a problem with the DS1 interface board, and any 
problems on the associated DS1-BD or UDS1-BD should be 
resolved first.)

 2 of 5