Avaya 03-300430 User Manual

This test updates the analog port’s message lamp state (if it has one) and translations with 
information in the software.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

FAIL

The port's battery feed chip is unable to supply sufficient power to the 
terminal equipment. This could be a marginal test, and the terminal 
equipment may be operating satisfactorily.

1. Retry the command at 1-minute intervals up to 5 times.

2. If the test continues to fail, determine whether the customer is 

experiencing problems on this line. Replace the circuit pack only if the 
customer is experiencing problems.

PASS

The port’s battery feed chip can provide power to the station equipment to 

detect on-/off-hook, but may not be able to supply power for touch tones. If 

touch tones are inoperative on this station, then replace the circuit pack 

because this port is inoperative.
User-reported troubles on this port should be investigated by using other port 

tests, by examining station wiring, or by examining the station.

 3 of 3

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1004

ABRT

The port was seized by a valid call during the test, and the test was 
aborted. Use display port location to determine the station 

extension. Use status station to determine the service state of the 

port. If the port is in use, wait until port is idle.

1. Retry the command at 1-minute intervals up to 5 times.

 1 of 2