Avaya 03-300430 User Manual

This test is nondestructive.
This test queries the SNC circuit pack for status of the background tests run on-board. These 
background tests include an SNC on-board microcontroller test, clock test, an SNC on-board 
Stratum-3 oscillator test, and TPN microcontroller test.

0

NO

BOARD

No board was detected by the test.

1. Check that SNC board is properly translated and inserted.

2. Run the test again. If it fails, reset the board. An SNC should be reset 

instead of reseating the circuit pack. The reset board command 

should almost never be used on an SNC. It may be necessary to use 
reset board if the SNC circuit pack gets into a mode where it 

cannot communicate with software. If an SNC with active errors and 
alarms is reset, the errors and alarms may take a while to come back, 
therefore reset board can mask real problems.

3. Run the test again. If it fails, the ID chip on board may be bad. 

Replace the board and retest.

 3 of 3

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 3 times.

2300

ABRT

The downlink message necessary to run this test could not be sent.

1. Retry the command at 1-minute intervals up to 3 times.

2301

ABRT

The software timer could not be set before sending the downlink message 
necessary to run this test.

1. Retry the command at 1-minute intervals up to 3 times.

 1 of 3