Avaya 03-300430 User Manual

1000

ABRT

The system resources required to run this test are not available. The 
port may be busy with a valid call.

1. Use display port location to determine the trunk group/

member number of the port. Use status bri-port 
location to determine the service state of the port. If the 

service state indicates that the port is in use, the port is 
unavailable for certain tests. Wait until the port is idle before 
retesting.

2. If the port is idle, retry the command at 1-minute intervals up to 5 

times.

1002

ABRT

The system could not allocate time slots for the test. The system 
may be under heavy traffic conditions or it may have time slots 
out-of-service due to TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling heavy 

traffic, repeat test at 1-minute intervals up to 5 times.

1003

ABRT

The system could not allocate a tone receiver for the test. The 
system may be oversized for the number of Tone Detectors present 
or some Tone Detectors may be out-of-service.

1. Resolve any TTR-LEV errors.

2. Resolve any TONE-PT errors.

3. If neither condition exists, retry the test at 1-minute intervals up 

to 5 times.

1004

ABRT

The port has been seized by a user for a valid call. Use status 

trunk for the trunks associated with this port and determine when 

the port is available for testing.

4. Retry the command at 1-minute intervals up to 5 times.

5. If the test continues to abort and the port is idle, escalate the 

problem.

1005

ABRT

This test is not valid for this type of translation. Ports administered as 

ASAI or ADJK cannot run this test because the B channels 

associated with the port are not used by ASAI or Avaya Adjunct Links. 

This is a normal condition.

 / 

:

1412

ABRT

This test does not execute on a G700 media gateway.

 1 of 2