Avaya 03-300430 User Manual

This test is nondestructive.
This test performs a service state audit on an ISDN B channel. The test passes if Call 
Processing informs Maintenance that the Restart message was transmitted successfully, or if 
the B channel was busy and could not send the message.
The test fails if the board is not inserted or translated properly, or if a reply is not received within 
a certain amount of time.
The test aborts if the signaling link is disconnected, if a message is already outstanding, or if the 
necessary resources could not be allocated.
Use status trunk grp#/mem# to investigate the service state of a TN2185 Trunk-Side ISDN 

BRI channel.

1114

ABRT

The signaling link is in a transitional state.

1. Retry the command at 1-minute intervals up to 5 times.

2. If the test continues to abort, escalate the problem.

8

FAIL

The signaling link is down.

1. Consult the procedures for the TBRI-PT MO.

9

FAIL

The port is out of service.

1. Return the port to an in-service state.

PASS

The signaling link is connected and operating normally.

 2 of 2

1000

ABRT

System resources required to run this test are not available. The port may 
be on a valid call. Use status trunk to determine when a trunk is 

available for testing.

1. Check the results of Test #1251 (Signaling Link State Check).

 1 of 2