Avaya 03-300430 User Manual

ABRT

System resources required for this test are not available.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test were not available. 
The port may be busy with a valid call.

1. Use display port location to determine the trunk 

group/member number of the port. Use status trunk to 

determine the service state of the port. If the service state 
indicates that the port is in use, then the port is unavailable 
for certain tests. Wait until the port is idle before retesting.

2. If the port status is active but the port is idle (no calls), 

check the error log for Error Type 1025 (see the error log 
table for a description of this error and required actions). 
The port may be locked up.

3. If the port status is idle, retry the command at 1-minute 

intervals up to 5 times.

1001

ABRT

System resources required to run this test are not available.

1. Retry the command at 1-minute intervals up to 5 times.

1002

ABRT

The system could not allocate time slots for the test. The 
system may be under heavy traffic conditions, or it may have 
time slots out of service due to TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling 

heavy traffic and the port status is idle, retry the command 
at 1-minute intervals up to 5 times.

1003

ABRT

The system could not allocate a tone receiver for the test. The 
system may be oversized for the number of tone detectors 
present or some of the tone detectors may be out of service. 
Enter list measurements tone-receiver to display 

basic information about the system's tone receivers.

1. Resolve any TTR-LEV errors.

2. Resolve any TONE-PT errors.

3. If neither condition exists, retry the test at 1-minute 

intervals up to 5 times.

 1 of 3