Avaya 03-300430 User Manual

FAIL

This can be due to either on- or off-board problems. Off-board 
problems of concern include EXP-PN and EXP-INTF faults 
(

), RMC-ENV faults (

), TDM-BUS faults, and 

faults associated with the tone detectors/tone generators. 
Clear every off-board problem before replacing the board. 
Keep in mind that a TDM-BUS problem is usually the result of 
a faulty board connected to the backplane or bent pins on the 
backplane.

1. Resolve any EXP-PN, EXP-INTF, or RMC-ENV errors.

2. Resolve any TDM-BUS errors.

3. Resolve any TONE-BD and/or TONE-PT errors.

4. Retest when the faults from steps 1, 2, and 3 are cleared. 

Replace the board only if the test fails.

PASS

The port is correctly using its allocated time slots. User-reported 

troubles on this port should be investigated using other port 

tests and by examining station, trunk, or external wiring.

0

NO BOARD

The test could not relate the internal ID to the port (no board). 
This could be due to incorrect translations, no board is 
inserted, an incorrect board is inserted, or an insane board is 
inserted.

1. Check to ensure that the board’s translations are correct. 

Use list config, and resolve any problems that are 

found.

2. If the board was found to be correctly inserted in step 1, 

enter busyout board location.

3. Enter reset board location.
4. Enter release board location.
5. Enter test board location long. This should 

re-establish the linkage between the internal ID and the 
port. If not, check that there is a valid board inserted.

 3 of 3