Avaya 03-300430 User Manual

14

(cont’d)

30

MAJ

5. Verify whether or not these commands were executed by 

issuing a show sync timing command to ensure that the 

source is provisioned and active, or visually inspect the Yellow 
LED on the MM710 Media Module.
Note: When the Yellow LED is on 2.7 seconds and off 0.3 
seconds, this means the tone-clock synchronizer is in “active” 
mode, and an external synchronization source is being used as 
a synchronization reference. Setting the sync timing was 
successful.
When the Yellow LED is on 0.3 seconds and off 2.7 seconds, 
this means the tone-clock synchronizer is in “active” mode and 
the internal (on-board) clock is being used as a synchronization 
reference. Setting the sync timing was not successful.

6. If there is more than one MM710 Media Module, and they have 

been set up as primary and secondary, this behavior could be 
on the second and not the timing of the bus.

For more details, please consult the maintenance documentation 

under LEDs and T1/E1 Media Module, or see
 

 

15

32

MAJ

cmgVoipHardwareFault — A DSP complex serving the VoIP 
engines has failed.

1. Check IP configuration.

2. Reset or replace Media Module.

50

cmgModuleRemove — A Media Module has been removed.

16

51

Reserved

52

cmgModuleInsertFault — The insertion sequence for a Media 

Module has failed.

53

cmgModuleInsertSuccess — A Media Module has been inserted.

54

cmgMgBusyout — An administrator has busied-out a Media Module 

or a port.

55

cmgMgRelease — An administrator has returned a busied-out 

media module or port back into service.

56 – 

69

Reserved

 10 of 20