Avaya 03-300430 User Manual

1003

ABRT

The system could not allocate a tone receiver for the test.  The system 
may be oversized for the number of Tone Detectors present or some Tone 
Detectors may be out-of-service.

1. Resolve TTR-LEV errors.

2. Resolve TONE-PT errors.

3. Retry the test at 1-minute intervals up to 5 times.

1004

ABRT

The port was seized by a valid call during the test.  The test has been 
aborted.

1. Use display port location to determine the station extension. 

Use status station to determine the service state of the port. If the 

service state indicates that the port is active, then the port is 
unavailable for certain tests. Wait until the port is idle before retesting.

2. Retry the command at 1-minute intervals up to 5 times.

3. If the test continues to abort and the port is idle, escalate the problem.

1005

ABRT

The test was aborted due to a configuration problem.  This code occurs 
under either of the following conditions:

1. This test may not be applicable, or it may be disruptive to terminal 

equipment other than a voice terminal (for example, a modem pool 
member or music on hold).

2. The circuit pack is one of the following:

- TN742 vintage 13, 14, or 15

- TN769 vintage 3, 4, or 5

1018

ABRT

Test disabled by administration. The default for the Test field on the station 
screen is y; thus, you may want to determine why this field has been set to 
n on this station (this may be due to the ringing application test 48, which 
can be customer or terminal disturbing).

1. To enable the test for a particular station, enter change station 

extension and set the Test field to y.

1020

ABRT

The test did not run due to a previously existing error on the specific port or 
a more general circuit pack error.

1. Examine Error Log for existing errors against this port or the circuit 

pack and attempt to diagnose the previously existing error.

 2 of 4