Avaya 03-300430 User Manual

1006

ABRT

This port has been busied out by command or taken out-of-service by the 
failure of the NPE Crosstalk test.

1. Look in the Error Log for Error Type 18 (port busied out) for this port. If 

this error is present, then release the port with release station 
extension and run the test again.

2. Look in the Error Log for Error Type 1025 (NPE Crosstalk test failed) 

for this port.  If this error is present, then investigate the errors 
associated with the NPE Crosstalk test (#6) first.

3. Make sure that the terminal is connected and in service, and then 

retest.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1

FAIL

This does not indicate a hardware problem.  The switchhook audit failed, 
and the other updates were not performed because of this failure.  This 
condition may occur when the audit is performed at the same time that the 
terminal equipment goes off-hook.  Use status station to determine 

when the port is available for testing.

1. When the port becomes available for testing, retry the command at 

1-minute intervals up to 5 times.

5

FAIL

This does not indicate a hardware problem but may indicate an internal 

software error.  The message waiting lamp update failed.  The translation 

and ringer updates were not performed because of this failure.

7

FAIL

The translation update failed.  The ringer update was not performed 

because of this failure.  This does not indicate a hardware problem but may 

be an internal software error.

8

FAIL

This does not indicate a hardware problem but may be an internal software 
error.  The ringer update failed.

1. Retry the command at 1-minute intervals up to 5 times.

 2 of 3