Avaya 03-300430 User Manual

Page of 2574
AN-LN-PT (Analog Line Port)
Issue 1 June 2005
443
 
Analog Looparound Test (#161)
S8300
 / 
G700
: T
his test aborts with Error Code 1412.
This test checks the on-board transmission capabilities of the NPE, the codec, and the battery 
feed chip of the analog port.  The test passes if the signal measured by the Tone Detector is 
within acceptable limits.
Table 131: Test #161 Analog Looparound Test 
Error
Code
Test
Result
Description / Recommendation
ABRT
Necessary system resources could not be allocated to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
1000
ABRT
System resources are unavailable.  The port may be busy with a valid call.  
This result is also reported for the system’s Music-On-Hold port when it is 
off-hook, which it usually is.
1. Enter display port location to determine the station’s extension.
2. Enter status station extension to determine the service state of 
the port.
3. If the port is active, wait until it is idle.  Retry the command at 1-minute 
intervals up to 5 times.
4. If the test continues to abort, escalate the problem.
1002
ABRT
The system could not allocate time slots for the test.  The system may be 
under heavy traffic conditions or have time slots out-of-service due to 
TDM-BUS errors.
1. Refer to “TDM-BUS” to diagnose any active TDM-BUS errors.
2. If the system has no TDM-BUS errors and is not handling heavy traffic, 
retry the command at 1-minute intervals up to 5 times.
3. If the test continues to abort, escalate the problem.
 1 of 4