Avaya 03-300430 User Manual
ATM-EI (Expansion Interface Circuit Pack)
Issue 1 June 2005
533
f. Error Type 131: An ATM-EI circuit pack has been removed from the slot for 5 minutes.
1. Insert the ATM-EI circuit pack into its administered slot.
2. Another way to resolve or prevent this alarm is to remove the ATM-EI administration (see
on page 528), then remove the ATM-INTF administration
(change circuit-pack).
It is possible that the ATM-EI could be held in reset by the PN’s Maintenance board and is
not inserted in the system.
not inserted in the system.
3. Try issuing test maint P long on the maintenance board in the same PN.
g. Error Type 257: Expansion Interface Control Channel test (#316) failed (board cannot
communicate on the TDM bus control channel). Follow the suggested test procedures.
Error Type 258: The archangel is out of sequence (Aux Data indicates angel number).
Error type 259: The expansion archangel link (EAL) to the active ATM-EI board is down.
See
See
h. Error Type 513: The ATM Crosstalk test failed. The board is either writing to or reading
from a TDM time slot that is not allocated to the board.
1. Test the board (test board location), and follow the test procedures suggested for
this test. In random tests of a single DSP during low or high traffic, the same DSP can be
tested more than once.
tested more than once.
i. Error Types 769 and 770: are board-degraded alarm errors that result when the ATM
switch is sending corrupted cells or excessive AAL/LAPD retransmissions (off-board ATM
cell corruption errors). These errors indicate the detection of a problem in handling ATM
cells that are received from the fiber interface.
cell corruption errors). These errors indicate the detection of a problem in handling ATM
cells that are received from the fiber interface.
Aux Data for these Error Types:
The problem is most likely not on the ATM-EI circuit pack reporting the errors, but it could be
due to one or more of the following reasons:
due to one or more of the following reasons:
●
The fiber is not snugly connected to either the board or the ATM switch.
●
The PN’s packet bus is corrupting the cells. See
(Aux Data 35 only).
●
The fiber between the ATM switch and the ATM-EI is too long (greater than 2 km for
multimode fiber). Use loopback to see if the fiber is corrupting the cells.
multimode fiber). Use loopback to see if the fiber is corrupting the cells.
Error Type
Aux Data
Description
769
34
Excessive AAL-5 retransmission requests
769
35
Excessive LAPD retransmission requests
770
25
Uncorrectable ATM cell headers – threshold
771
26
VPI, VCI pair unknown