Avaya 03-300430 User Manual

This test is not executed for ASAI adjuncts because adjuncts do not support MIMs upon which 
this test is based.

1000

ABRT

Could not seize the endpoint or B channels for test.

1. Retry the command at 1-minute intervals up to 5 times.

2. If the test continues to abort, escalate the problem.

1005

ABRT

The endpoint’s MIMs Supported field is administered to “no.”

1. Use change station extension to change parameter only if the 

endpoint documentation reflects support for ISDN-BRI Management 
and Maintenance Procedures.

1113

ABRT

The signaling link between the switch and the endpoint is down.

1. Use test port location long to clear any errors that prevent 

establishment of the signaling link.

2. Examine the results of the Signaling Link Status test (#626) that is run 

as part of this command.  If this test aborts or fails, follow the repair 
procedure for Test #626.

3. If the XID test (#628) continues to abort, escalate the problem.

1139

ABRT

The PN’s packet bus is out-of-service.

1. Follow the repair procedures for the packet bus.

2. After completing step 1, execute test port long location,  and 

review the results of the BRI Port Local LAN Loop Around test (#618) 
to verify the repair.

1141

ABRT

The PKT-CTRL is out-of-service.

1. Refer to PKT-CTRL (Packet Control Circuit Pack) Maintenance 

documentation.

2. If step 1 does not resolve the problem, escalate to the next tier.

 1 of 3