Avaya 03-300430 User Manual

2069

ABRT

The endpoint has returned an error response to the application message 

sent by the switch.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

2. If the test continues to abort, escalate the problem.

2000

FAIL

No loop back activation or deactivation response is received from the 
endpoint.

1. Consult the endpoint documentation to determine if ISDN-BRI 

Management and Maintenance Procedures are supported. If not 
supported, use change station extension to set the MIMs 
Supported field to n. Use busyout station extension and 
release station extension to busyout and release the endpoint 

to resolve any endpoint alarms resulting from failure of this test.

2. If the endpoint supports these procedures and the test continues to fail, 

assume the endpoint is defective and replace it.

2071

FAIL

No data is detected on Channel B1 during loop back.

2072

FAIL

No data is detected on Channel B2 during loop back.

1. Replace the endpoint and repeat test.

2. If test continues to fail, check the wiring between the endpoint and the 

switch and repeat the test.

PASS

The endpoint has responded to the switch activate and deactivate loop back 

application messages. Data has been detected on the looped back 

channels.

 3 of 3