Avaya 03-300430 User Manual

FAIL

The trunk cannot be seized for an outgoing call.  This could cause in-line 
failures to be reported against the trunk (no answer would report error 
type 257 with auxiliary data 57487 in the error log).

1. Verify the Trunk Type field on the trunk administration screen 

screen matches the trunk type administered on far-end switch.

2. Look for DS1-BD/UDS1-BD errors in Error Log.  If present, see 

3. Retry the command at 1-minute intervals up to 5 times.

PASS

The trunk can be seized for an outgoing call.

0

NO

BOARD

The test could not relate the internal ID to the port (no board).
This could be due to incorrect translations, no board is inserted, an 
incorrect board is inserted, an insane board is inserted, or the board is 
hyperactive.

1. Verify that the board’s translations are correct.  Enter list config, 

and resolve any problems that are found.

2. Enter busyout board location
3. Enter reset board location
4. Enter release board location
5. Enter test board location long

This should re-establish the linkage between the internal ID and the port.  If 

not, dispatch to verify that a valid board is inserted.

Note:

Hyperactivity causes some special problems with the 
sequence suggested above.  If the ports are translated 
after issuing list config but the Vintage field shows 

that there is no board (when there really is a board), 
busyout board and release board do not work, even 

though reset board does work.  The software puts the 

hyperactive board back in service after the hyperactivity 
clears.

 4 of 4