Avaya 03-300430 User Manual

1000

ABRT

The port was seized by a user for a valid call.

1. Use display port location to determine the trunk group/member 

number of the port.  Use status trunk to determine the service state 

of the port.  If the port is active, wait until it is idle before testing.

2. If the port status is active but the port is idle (no calls), check the error 

log for error type 1025 (see the error log table for a description of this 
error and required actions).  The port may be locked up.  Check the CO 
wiring, check for excessive loop current, and check the trunk 
translations.  (If the trunk is translated incorrectly, this test will abort.)

3. If the port status is idle, busyout and release the trunk, and retry the 

command at 1-minute intervals up to 5 times.

4. If the test still aborts, replace the circuit pack.

1001

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1002

ABRT

The system could not allocate time slots for the test.  The system may be 
under heavy traffic conditions or it may have time slots out-of-service due to 
TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling heavy traffic, 

retry the command at 1-minute intervals up to 5 times.

1003

ABRT

The system could not allocate a tone receiver for the test.  The system may 
be oversized for the number of Tone Detectors present, or some Tone 
Detectors may be out of service.

1. Resolve any TTR-LEV errors.

2. Resolve any TONE-PT errors.

3. If neither condition exists, retry the command at 1-minute intervals up to 

5 times.

1004

ABRT

The port was seized by a valid call during the test.  The test has been 
aborted.

1. Use display port location to determine the trunk group/member 

number of the port.  Use status trunk to determine the service state 

of the port.  If the port is active, wait until it is idle before testing.

 2 of 3