Sony NSR-1050H User Manual

NSR-1000 Series v1.1.1 Release Note 

・ 

The image size of more than QVGA(320x240) is selected, the maximum 

frame rate is limited at the transmission side as follows: 

NTSC:    10 fps or less 
PAL:        8 fps or less 

 

・ 

If the cameras mentioned below uses the MPEG4 codec with the image size of 

more than 384x288, the maximum frame rate is limited at transmission side. 
(V11N:59) 

      SNC-CS50, SNC-DF50/DF80/DF85, SNC-RX530/RX550/RX570, SNC-RZ50 

・ 

15(NTSC)/20(PAL) fps or less with the stabilizer set to on   

・ 

20(NTSC)/16(PAL) fps or less when the dual codec including JPEG and 
anything is selected, or while the motion detection is working 

 

・ 

When you want to select the image size of more than 4CIF on the SNC-DF85, 

the firmware version of the camera should be V1.20 or higher. If the former 
version, do not select 4CIF in the image size setting. (V11N:226) 

 

・ 

To configure the camera protocol on camera servers SNT-EX series connected to 

analog cameras, access the setting page through the web browser of the 
SNT-EX series. (V11N:169) 

 

・ 

With regard to the SNT-EX154, audio data of channel 1 only is output through 
CH1 AUDIO OUT connector of the SNT-EX154.(V11N:283) 

 

・ 

I/O pins of the SNT-EX series are shared with all the video channels. It is 
possible for the channel 1 to use all the I/O pins, or for each channel to use each 
pin one by one. 
If the output pins are shared with two or more video channels, there may be 
some inconsistencies occurring. To work around this, it is recommended to 
assign output pins to any one of the channels. (V11N:284) 

 

・ 

The detection area configuration in the VMD (Camera) Configuration screen is 
performed based on the VGA (640x480) coordinate system. Note that it shows 

- 13 -