Petsafe PIF00-12917 User Manual

22 1-800-732-2677

 

www.petsafe.net 23 

• Yes. You may use any 3/4 inch, non-metallic collar.

• Check your pet’s neck daily for irritation from the 

Contact Points.

• Check the Contact Points on the Receiver Collar weekly to 

make sure they are clean.

• Use the Contact Point Wrench to make sure the Contact 

Points are secure. Do not over tighten.

• Check the fit of the Receiver Collar weekly.

• The Receiver Indicator Light acts as a Battery Status Indicator, 

flashing red every 4 to 5 seconds when battery charging is 

required.

• Check Battery Status Indicator Lights.

• Yes. Placing the Transmitter inside a metal building can reduce 

the maximum range of the Stay + Play Wireless Fence

™

.

• Parking a vehicle within the Pet Area, can reduce the range of 

the system and cause your pet to receive a Static Correction 

where it otherwise would not if the vehicle was not there. 

• Fixed large metal objects such as metal sheds can affect the 

signal by reducing the maximum range of the system at the 

location of the object. As a result, your pet may receive a 

Static Correction. 

• This condition is due to the Contact Points irritating the skin. 

Discontinue use of the Receiver Collar for a few days. If the 

condition persists beyond 48 hours, see your veterinarian. 

Once the skin returns to normal, replace the Receiver Collar 

and monitor the skin condition closely.

• No. This can result in pulling the Contact Points too tightly 

against your pet’s neck or the collar may break. Attach a 

leash to a separate, non-metallic collar positioned above the 

Receiver Collar.

• The tone only mode can be used in training your pet to his 

boundary or for well-trained pets that no longer require 

Static Correction.

• A beeping tone indicates power loss. If the Transmitter fails 

to transmit a proper signal, a continuous alarm will sound. 

Contact the Customer Care Center at 1-800-732-2677.

• The Power Loss Alarm in the Transmitter is activated to alert 

you that power has been removed from the Transmitter and 

your pet is no longer being contained. To turn off the Power 

Loss Alarm, unplug the Power Adapter from the Power Jack 

located on the bottom of the Transmitter or press the Alarm 

Disable Button for 5 seconds then release.

• The Transmitter has a built in Transmission Failure Alarm 

that continuously monitors the Transmitter output. If 

a transmission failure ever occurs the alarm warns you 

that your pet is no longer being contained. Contact the 

Customer Care Center for a replacement Transmitter.