Hughes DW6000 User Manual
38
DW6000 Troubleshooting
The pedestal base
Follow the instructions below to place the DW6000 in the pedestal base, or
remove it from the base.
remove it from the base.
You do not have to use the pedestal. You can place the DW6000 in a horizontal
position if you prefer. If you do this, make sure you never put anything on top
the DW6000. Doing so may damage the unit by interfering with air circulation,
which cools the unit.
position if you prefer. If you do this, make sure you never put anything on top
the DW6000. Doing so may damage the unit by interfering with air circulation,
which cools the unit.
1. Take the pedestal base in one hand the DW6000 in the other. Orient them as
shown in Figure 25. The Power LED will be at the bottom.
2. The pedestal base has two curved ridges, one on each side of its opening.
See Figure 26. The DW6000 has six guides that slide along these ridges.
See Figure 27. Locate the ridges and the two guides at the front of the
pedestal base.
See Figure 27. Locate the ridges and the two guides at the front of the
pedestal base.
3. Align the guides with the ridges.
4. Gently slide the guides along the ridges until the DW6000 clicks into place.
4. Gently slide the guides along the ridges until the DW6000 clicks into place.
S
Note:
If you need to remove the DW6000 from the pedestal
base, pull up and back on the clip on the back of the base. See
Figure 28. You can then slide the base off the DW6000.
Figure 28. You can then slide the base off the DW6000.
Figure 25: Orienting pedestal base and DW6000