Manualsbrain.com
  1. Manuals
  2. Brands
  3. Panasonic
  4. TQBJ0349
  5. User Manual

Panasonic TQBJ0349 User Manual

Download
Page of 95
PROJECTOR SETUP menu
64
 - ENGLISH
Settings
NO SIGNAL SHUT-OFF
 
J
If no signal is input within a preset time, the projector 
power is automatically switched to the standby state.
Select [NO SIGNAL SHUT-OFF] in Step 
1. 
3.
Press ◄► to switch [NO SIGNAL 
2. 
SHUT-OFF] setting.
DISABLE
The NO SIGNAL SHUT-OFF is 
ineffective.
10 to 90 minutes The Auto Power-Off time can be 
set in 10 minute increments.
STANDBY MODE
 
J
This function can set the electric power when the 
projector is standing by.
Select [STANDBY MODE] in Step 3.
1 ) 
Press ◄► to switch [STANDBY MODE] 
2 ) 
setting.
The setting will change as follows each time the 
 
z
button is pressed.
NORMAL
ECO
Note
If STANDBY MODE is set to [ECO], you cannot use 
 
z
network functions when the projector is standing by. Also, 
you cannot use some RS-232C protocol commands. 
When you turn the POWER switch [ON], display of 
the initial image may be delayed for approximately 
10 seconds when compared with [NORMAL] mode 
operation.
If set to [NORMAL], you can use network functions when 
 
z
the projector is standing by.
SCHEDULE
This sets the command execution schedule for each 
day of the week.
 
J
How to enable the SCHEDULE 
function
Press ▲▼ to select [SCHEDULE].
1 ) 
Press ◄► to switch [SCHEDULE].
2 ) 
The setting will change as follows each time 
 
z
◄► is pressed.
ON
OFF
Note
If [SCHEDULE] is set to [ON], the setting for [STANDBY 
 
z
MODE] is automatically set to [NORMAL] and cannot be 
changed. Even if [SCHEDULE] is then set to [OFF] when 
in this state, the setting of [STANDBY MODE] remains at 
[NORMAL].
 
J
How to assign a program
With [SCHEDULE] switched to [ON], 
1 ) 
press <ENTER> button.
The [SCHEDULE] screen will be displayed.
 
z
Select and assign program to each day 
2 ) 
of week.
Press ▲▼ to select a day of week and press 
 
z
◄► to select a program number.
You can set the program from No.1 to No.7. 
 
z
“- - -” indicates that the program number has 
not been set yet.
 
J
How to set a program
You can set up to 16 commands to each program.
On the [SCHEDULE] screen, press ▲▼ 
1 ) 
to select [PROGRAM EDIT].
Press ◄► to select a program number 
2 ) 
to be set and press <ENTER> button.
Press ▲▼ to select a command 
3 ) 
number and press <ENTER> button.
You can change the page using ◄►.
 
z