Panasonic PT-AX200E User Manual

You can select the required duration of time and set the 
off timer to turn off the power of the projector 
automatically. 3 minutes before turn-off, the countdown 
of minutes will be displayed in the lower right corner. 
Press I H to cycle through the options.

If you use the projector at high elevation, the ALTITUDE 
setting need to be HIGH to set the fan speed high. Press 
I H to select the required option.

 

The fan speed is low.

 

The fan speed is high.

You can adjust the power of the lamp to save electricity, 
prolong the lamp life and reduce the noise.

You can check how long time the lamp has been used.

You can use the 2 different test patterns to adjust the 
focus of the image. 

1. Press the ENTER button to display the test 

pattern 1 and adjust the focus with the focus ring.

2. Press the ENTER button to display the test 

pattern 2 and adjust the focus with the focus ring 
again.

3. Press the MENU or RETURN to return to the 

previous menu, or press repeatedly to return to the 
screen.

• At 1 400 m (4 593 ft) above sea level, the setting must 

be HIGH.

• The loudness of fan noise depends on the ALTITUDE 

setting.

When higher luminance is 
required.

When lower luminance is 
sufficient.

• When no input signal is detected, the function is 

disabled.

• LAMP RUNTIME is a relevant matter for lamp 

replacement timing. See “Replacing the lamp unit” on 
page 42.

• When the projector and/or the screen is tilted, adjust 

the focus at the centre of the image. The upper and 
lower edge might be out of focus.

• When the image is distorted in keystone, adjust the 

KEYSTONE in the POSITION menu.