Intel 1000LX User Manual
GB2.book : GB203 11 Tue Oct 27 13:01:06 1998
11
C H A P T E R
3
Configure the module and connect the cables
Cabling the Module
Introduction
The cable connections to the module depend on the mode in which
the module is to be used.
the module is to be used.
Stand-alone Mode
Cabling for a single switch
Follow these instructions to provide a high-speed (1000Base-SX/
1000Base-LX) link between the switch containing the 1000Base
Module and another switch, device or group of switches:
1000Base-LX) link between the switch containing the 1000Base
Module and another switch, device or group of switches:
Warning
When used in stand-alone mode, this module must not
be installed in a switch containing a Stack Interface
Module, a Matrix Module or a 1000Base Module set in
stack mode.
be installed in a switch containing a Stack Interface
Module, a Matrix Module or a 1000Base Module set in
stack mode.
1
Plug the SC connectors on the optic fiber cable into the RX and
TX sockets on the 1000Base-SX/1000Base-LX connector.
TX sockets on the 1000Base-SX/1000Base-LX connector.
2
Plug the other end of the cable into a device and check the
LEDs on the 1000Base Module to verify the link. For informa-
tion on the LEDs, see Chapter 2.
LEDs on the 1000Base Module to verify the link. For informa-
tion on the LEDs, see Chapter 2.
1000Base-SX
Stack Interface Module
CLASS 1 LASER PRODUCT
1000SX Module for 500 Series Switches
1716