Genie 3062m3064 User Manual

5

NOTE: Before programming the operator, check to make sure 

Now that the garage door opener is installed, follow the 

steps in this manual to program the opener so that the door 

opens and closes properly and all remote devices operate 

correctly. The following steps are a guide to setting opener so 

it functions properly.

The following steps list the order of programming the opener’s 

functional settings for use.

1. 

“TRAVEL LIMITS” 

2. 

“FORCE and SPEED CONTROLS” 

3.  

“REMOTE PROGRAMMING”

This section describes the programming functions of the 

opener. Use the following information to understand the 

buttons, LED indicators and products used to program 

functions.

Powerhead: There are 3 programming buttons and 2 LED 

lights on the powerhead. Each of the buttons are used to enter 

and complete the setup programming. The LED lights indicate 

status or a function change by illuminating ON, OFF, or ON 

FLASHING in one of three different colors: blue, red or purple.

1.  Door Travel Limits.

 -

This program is used to set how far the door travels 

up and down.

2.  Remote Programs (default menu)–only required for added  

remote control transmitters.

 -

Describes how to program remotes to sync with 

additional remote control devices, wall consoles, 

keypads and the powerhead.

3.  Force Setting Program.

 -

 This program controls the force applied during the 

closing and opening of the door. They are factory set 

and will rarely require adjustment only under certain 

circumstances.

4.  Door Speed Program.

 -

 This program does not require manually initiated 

changes.

Travel Limits Programmable setting to adjust how far door 

travels up or down.

Force Control refers to how much power is needed to 

move (open/close) a particular door and does NOT require 

programming.

Speed Control refers to how fast or slow the opener opens 

and closes the door. This is factory set and does NOT require 

programming. NOT available on all models.

Remote Programming synchronizes remote devices 

(remote, wall console, and keypad) with the powerhead.

Moves door up or down during 

programming and advance 

through menus.

Enters into and selects 

programming menus.

NOTE: 

•  Just remember—the pointed end of the button (like an arrowhead) 

points in the direction the carriage will move when that button is 

pushed.

DOOR

Standing under the opener’s powerhead – facing the door – looking up 

– this is the view you will see of the programming buttons and LEDs. 

Indicator LED’s

Up Travel 

Down Travel

Programming/Menu

NOTE: The 3 programming buttons are for programming ONLY.