Lexmark X940e Installation Guide

Make sure the USB drive is supported. For information regarding tested and approved USB flash memory devices,
visit the Lexmark Web site at www.lexmark.com.

These are possible solutions. Try one or more of the following:

Make sure Ready or Power Saver appears on the display before sending a job to print. Press 

 to return the

printer to the Ready state.

Remove the stack of paper from the standard exit bin, and then press 

.

Load paper in the tray.

Verify that you are using the correct printer software.

If you are using a USB port, make sure you are running Windows Vista, Windows XP, Windows Server 2003,
Windows 2000/98/Me and using compatible printer software.

Make sure the internal print server is properly installed and that the printer is connected to the network. For more
information about installing a network printer, click View User's Guide and Documentation on the Software
and Documentation CD.

Print a network setup page and check that the status shows Connected. If the status is Not Connected, check
the network cables, and then try printing the network setup page again. Contact your system support person to
make sure the network is functioning correctly.

Copies of the printer software are also available on the Lexmark Web site at www.lexmark.com.

For more information, visit the Lexmark Web site at www.lexmark.com.

Check the cable connections to the printer and print server to make sure they are secure.

For more information, see the setup documentation that came with the printer.

Make sure the Paper Type setting matches the paper loaded in the tray.