Xerox Document Workstation with PlotWorks Support & Software User Guide

Chapter 9-22 • PlotWorks User Guide

1.

Click the General Configuration tab.

2.

In the Original Size pull-down field, select one of the following options:

•

Select the actual document size, or:

•

Select AUTO STANDARD SIZE to have the software automatically 
detect the closest (higher) standard size.

In the Size field, select one of the following options (some of these settings might 
not be available, depending on the scanner you are using):

•

Select USER SIZE, then enter the document’s width and height values in the 
Width and Height fields. 

•

Select AUTO SIZE to have the scanner automatically detect the actual width 
and height. Only available on the Xerox 7356, Vidar Flash and Vidar Flash+ 
scanners.

•

Select AUTO STANDARD SIZE to have the software automatically detect 
the closest (higher) standard size.

•

Select AUTO STANDARD WIDTH to have the software automatically 
detect the closest (higher) standard width. PlotWorks detects the actual height 
of the document, even if it is not a standard size. When this option is selected, 
a length must be specified.

•

Select AUTO HEIGHT to have the software automatically detect the height 
of the document. The user sets the actual width of the document. 

•

AUTO SIZE 9” SERIES (Xerox 7336 only). Automatically detects the 
image size when it is scanned and selects the appropriate Architectural size. 

•

AUTO SIZE 8.5” SERIES (Xerox 7336 only). Automatically detects the 
image size when it is scanned and selects the appropriate ANSI size.

You can offset your scanned image from the edge of the page. 

•

To set the offset:

1.

Click the General Configuration tab. (See )

2.

Enter an X offset distance (inches or mm) in the X offset box.

The X offset limit is “X + document width” not to exceed 36 inches.

3.

Enter a Y offset distance (inches or mm) in the Y offset box.