Xerox XDPE/400 (also known as EOMS I-Services) Support & Software User Guide
Installing and Customizing XDPE/400 (9/2001)
4-11
Installation requirements
Interface settings
Verify that the interface between your AS/400 system and your Xerox
printer is set up to emulate an IBM printer and to convert SNA character
mode data. Table 4-8 shows the available interface emulation for each
printer mode. Refer to your specific printer manual for the correct
emulation setting for your printer.
For XPPM mode printers, be sure the Spur or the Solimar interface box is
For XPPM mode printers, be sure the Spur or the Solimar interface box is
set to emulate the 5225.
Also verify that the AS/400 can print to the Xerox printer using the AS/400
Also verify that the AS/400 can print to the Xerox printer using the AS/400
printer writer.
OS/400 device description
You must create a device description for your non-network or twinax
locally-attached Xerox printer. If your AS/400 is set up to automatically
configure devices upon connection, the system creates the device
description as soon as you plug in the printer. The OS/400 system value
QAUTOCFG specifies whether devices that are added to the system are
configured automatically.
You can refer to your OS/400 device description when you run sample
You can refer to your OS/400 device description when you run sample
jobs at the end of installation.
Table 4-8.
Interface emulation by printer mode
Printer type
Interface emulation
Interface data
conversion
XPPM
IBM 5219
1
or IBM 5225
1
Setup depends on the interface being used.
EBCDIC
XDPM
IBM 3812, IBM 5219, or IBM 5225 ASCII
PCL
For twinax only:
IBM 3812, IBM 5219, or IBM 5225
ASCII
PostScript
Not applicable
Not applicable