Xerox SmartSend Support & Software Installation Guide
Scanning Device Configuration
2-29
T
IP
:
If any Xerox Multifunction Devices intended for use with SMARTsend are already configured for use
with other scanning applications, then you should print and save a configuration sheet for those devices
before you configure them for use with SMARTsend. The configuration sheet lists the current network
scanning configuration, which may be useful in the future if the device needs to be reverted back to a
previous configuration.
before you configure them for use with SMARTsend. The configuration sheet lists the current network
scanning configuration, which may be useful in the future if the device needs to be reverted back to a
previous configuration.
Data Transfer Protocols
SMARTsend can configure various scanning-related settings on Xerox Multifunction Devices, but it does
not enable or change the data transfer protocol and option settings on the device or the SMARTsend
computer. Check the following configuration settings prior to adding devices to SMARTsend:
not enable or change the data transfer protocol and option settings on the device or the SMARTsend
computer. Check the following configuration settings prior to adding devices to SMARTsend:
If FTP will be used for filing scan jobs, then the IIS FTP server must be installed and running. See
Install and Configure IIS / FTP on page 2-10 for more information. This is the SMARTsend default.
Install and Configure IIS / FTP on page 2-10 for more information. This is the SMARTsend default.
If SMB will be used for filing scan jobs, then SMB must be supported on the device. In addition, File
and Printer Sharing for Microsoft Networks must be enabled on the Network Adapter on the
SMARTsend computer. See Enable File and Printer Sharing on page 2-9 for instructions.
and Printer Sharing for Microsoft Networks must be enabled on the Network Adapter on the
SMARTsend computer. See Enable File and Printer Sharing on page 2-9 for instructions.
If HTTP will be used for filing scan jobs, then HTTP must be supported and enabled on the device.
If HTTPS will be used for filing scan jobs, then SSL/HTTPS must be supported and enabled on the
device. In addition, the SMARTsend computer must have a security certificate installed.
device. In addition, the SMARTsend computer must have a security certificate installed.
TCP/IP Port Configuration
When configuring a device, SMARTsend uses the FTP, SMB, HTTP, and HTTPS ports that are defined on
the SMARTsend computer. Following are the standard settings for each supported filing protocol:
the SMARTsend computer. Following are the standard settings for each supported filing protocol:
Consider the following issues when configuring ports on your SMARTsend computer and Xerox devices:
Confirm that the ports required for each supported protocol are not blocked by filtering at a switch,
router, or firewall.
router, or firewall.
Port (139) must be used for SMB filing.
If non-standard ports are used on the SMARTsend computer, SMARTsend will configure the
corresponding ports on the Xerox devices that will be used with SMARTsend.
corresponding ports on the Xerox devices that will be used with SMARTsend.
N
OTE
:
If you attempt to add a Xerox Multifunction Device to SMARTsend using a protocol that the device
does not support, an alternate protocol will be used to configure the device. A status message will indicate
which protocol SMARTsend is using for data transfer. See Edit Device Configuration Defaults on page
4-18 for additional information.
which protocol SMARTsend is using for data transfer. See Edit Device Configuration Defaults on page
4-18 for additional information.
Protocol
TCP/IP Port
FTP
21
SMB
139
HTTP
80
HTTPS
443
Table 2-3: Standard TCP/IP Ports
N
OTE
:
Some Xerox devices may not support non-standard ports. If this is the case for your device,
reconfigure the SMARTsend computer to use a standard port and then reconfigure the device.