Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
5-10
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 5 Repairing and Maintaining the 8112 Server
Replacing the CD-ROM drive
Replacing the CD-ROM drive
This section describes how to replace a CD-ROM drive.
Warning
Handling the CD-ROM drive can result in static damage. Use an anti-static wrist strap,
static-dissipating work surface, and anti-static bags when handling and storing it.
static-dissipating work surface, and anti-static bags when handling and storing it.
Removing the old CD-ROM drive
Step 1
Verify that all of the steps in the
have been completed.
Step 2
Identify where the CD-ROM drive is located. It is always in the front of the server. See the
.
Step 3
Loosen the four captive screws in the corners of the drive bay housing in the front of the 8112 server.
See the
See the
Step 4
Loosen the four captive screws in the corners of the floppy drive housing in the back of the 8112 server.
See
See
Step 5
Pull the floppy drive housing partially out of the back of the chassis.
Step 6
From the back of the 8112 server, remove the IDE cable from the server’s inner connector and remove
the power cables from the CD-ROM drive.
the power cables from the CD-ROM drive.
Step 7
From the front of the 8112 server, slide the CD-ROM drive out.
Installing the new CD-ROM drive
Step 1
Loosen the four captive screws in the corners of the drive bay housing in the front of the 8112 server.
See
See
Step 2
Loosen the four captive screws in the corners of the floppy drive housing in the back of the 8112 server.
See
See
Step 3
Pull the floppy drive housing partially out of the back of the chassis.
Step 4
Locate the IDE cable and attach it to the back of the CD-ROM drive. Be sure to attach it the correct way.
Step 5
Thread the free end of the IDE cable through the empty CD-ROM drive slot from the front of the server
towards the back.
towards the back.
Step 6
Attach the power cable to the back of the CD-ROM drive.
Step 7
From the front of the 8112 server, gently slide in the CD-ROM drive as far as it can go.
Step 8
From the back of the 8112 server, pull the CD-ROM drive towards you as far as possible. Plug the
CD-ROM drive’s IDE cable into the server’s inner connector and plug the free end of the power cable
into the server.
CD-ROM drive’s IDE cable into the server’s inner connector and plug the free end of the power cable
into the server.
Step 9
Tighten the four captive screws in the corners of the floppy drive housing in the back of the 8112 server.
Step 10
Tighten the four captive screws in the corners of the floppy drive housing in the back of the 8112 server.