Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
5-13
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 5 Repairing and Maintaining the 8112 Server
Replacing a power supply unit
Figure 5-9
Removing a Power Supply Unit
Installing a new power supply unit
Warning
Do not touch any of the exposed leads, terminals, or components. Hazardous voltages, capable of
causing death, may be present in this product.
causing death, may be present in this product.
Step 1
Slowly slide the power supply unit sled into the chassis. Guides on the chassis and rails on the power
supply unit sled assist in properly aligning the power supply unit sled during insertion.
supply unit sled assist in properly aligning the power supply unit sled during insertion.
Note
The power supply unit sled should be inserted with a single, steady motion. Bouncing the power
supply unit sled during insertion may cause an alarm condition in the system.
supply unit sled during insertion may cause an alarm condition in the system.
Step 2
Tighten the two captive screws located at the bottom front of the power supply unit. See
.
Note
If you are replacing more than one power supply unit, follow the above procedure for each power
supply unit. Once they have all been replaced, attach the power cable to the back of the server
and power up the server. Refer to the
supply unit. Once they have all been replaced, attach the power cable to the back of the server
and power up the server. Refer to the
.