Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
7-12
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 7 Installing a Shadow Server
Restarting the shadow server
Restarting the shadow server
At this point, you must restart the shadow server.
Step 1
If not already connected, access the command line interface (CLI) by following the procedures in the
Step 2
Log in as technician. The tech$ prompt appears.
Step 3
At the tech$ prompt, type
restart enable
and press Enter.
Step 4
Type
y
and press Enter to confirm that you want to restart the system.
Verifying shadow server configuration while in standalone
mode
mode
The following steps must be done while the shadow server is still in standalone server mode.
Step 1
Confirm the shadow server functionality by completing the steps in the
.
Step 2
Verify that you can log into MeetingTime.
Step 3
Verify all gateway functionality and connectivity. Refer to the appropriate gateway system manager’s
guide for more information.
guide for more information.
Changing the shadow server to act as a shadow server
This section explains how to change the shadow server’s setup from standalone mode to shadow server
mode.
mode.
Note
If the “net” command is run at any point after the “setup” command, the setup configuration is
overwritten and must be redone.
overwritten and must be redone.
Step 1
If not already connected, access the command line interface (CLI) by following the procedures in the
Step 2
Log in as technician. The tech$ prompt appears.
Step 3
At the tech$ prompt, type
down
and press Enter.
Step 4
Type y and press Enter to confirm that you want to bring down the system.
Step 5
Once the system is down, type
setup
and press Enter. The first ten lines of “” on page <$chapnum13
appear.