Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
5-19
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 5 Repairing and Maintaining the 8106 Server
Replacing T1 Smart Blades or Smart Blades
Figure 5-14 Installing a T1 Smart Blade Card and Transition Module
Removing an old T1 Smart Blade or Smart Blade transition module
Step 1
Locate the T1 Smart Blade or Smart Blade card’s corresponding transition module in the back of the
server.
server.
Step 2
Loosen the T1 Smart Blade or Smart Blade transition module’s two captive screws on the left and right
of the panel. See
of the panel. See
Step 3
Press the ejector levers outward. This partially unseats the T1 Smart Blade or Smart Blade transition
module from the backplane connectors. See
module from the backplane connectors. See
Step 4
Pull the T1 Smart Blade or Smart Blade transition module from the chassis by pressing the ejector levers
outward and pulling the transition module out. See
outward and pulling the transition module out. See
.
Installing a new T1 Smart Blade or Smart Blade transition module
Step 1
Ensure that the system is powered down. If you are installing a new T1 Smart Blade or Smart Blade
transition module immediately after removing an old one, the system should still be powered down.
Otherwise, follow the steps in the
transition module immediately after removing an old one, the system should still be powered down.
Otherwise, follow the steps in the
.