Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
D-6
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Appendix D Configuring NSF Codes
Configuring NSF codes
Figure D-3
Modifying Outgoing NSF Codes
Step 5
Enter the NSF code type and press Enter. Depending on the installation, it is “service”, feature”, “parm
service”, or “parm feature”. Refer to worksheet F-1 in the MeetingPlace Audio Server 5.2 Installation
Planning Guide.
service”, or “parm feature”. Refer to worksheet F-1 in the MeetingPlace Audio Server 5.2 Installation
Planning Guide.
Step 6
Enter the NSF code value (BFCV) and press Enter. Refer to worksheet F-1 in the MeetingPlace Audio
Server 5.2 Installation Planning Guide.
Server 5.2 Installation Planning Guide.
Step 7
Enter the modified parameter, if there is one, and press Enter.
Note
The menu gives you the option of entering a second NSF code. If there is no second code, then
continue pressing Enter to bypass this.
continue pressing Enter to bypass this.
Step 8
The modify command prompt appears when you are finished, as shown in the last line of
.
Step 9
Type d and press Enter to modify the outgoing NSF Carrier Identification Code (CIC). See
.
Figure D-4
Modifying the NSF CIC
Enter modify command [table 50]: c
----------------- PROTOCOL TABLE 50 -----------------
------- To skip over a field, just press <cr> -------
Outgoing Network Specific Facilities (NSF) Codes
------------------------------------------------
NSF code 1 type [ not used] :
BFCV 1 value [not used] :
Extra 1 param [not used] :
NSF code 2 type [ not used] :
BFCV 2 value [not used] :
Extra 2 param [not used] :
Enter modify command [table 50]:
Enter modify command [table 50]: d
----------------- PROTOCOL TABLE 50 -----------------
------- To skip over a field, just press <cr> -------
Outgoing NSF Carrier Identification Code (CIC)
------------------------------------------------
CIC network type [ natl] :
CIC code [1288] :
Enter modify command [table 50]: