Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
3-14
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 3 Installing the 8106 Server
Mounting the 8106 server
Mounting into a frame relay rack
The 8106 server can be mounted in a 19-inch frame relay rack, which is common in Central Office
locations. In this configuration, the 8106 server is held along the front of the chassis.
locations. In this configuration, the 8106 server is held along the front of the chassis.
The following procedure describes how to install the 8106 server in a 19-inch frame relay rack:
Step 1
The 8106 system comes with two mounting brackets already attached to the front of the server. See
. The long sides of the brackets are fastened to the server.
Step 2
Slide the 8106 server into the front of the rack.
Step 3
Attach the 8106 server to the rack. The system is shipped with screws to attach the mounting brackets
to the rack.
to the rack.
Figure 3-5
Mounting into a Frame Relay Rack
Mounting into an EIA equipment rack
The 8106 server can also be mounted in a 19-inch EIA equipment rack. In this configuration, the server
is mounted on the back rails. The 8106 server comes with two mounting brackets already attached to the
front of the server. See
is mounted on the back rails. The 8106 server comes with two mounting brackets already attached to the
front of the server. See
.
To mount the server into an EIA equipment rack on the back rails, perform the following steps:
Step 1
Remove the mounting brackets from the front of the system and attach them to the back.
a.
Remove the two screws on each side of the back of the server (four total for the system) and put
them aside.
them aside.
b.
Remove the screws that secure the mounting brackets to the front of the system (two on each side).