Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
3-16
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 3 Installing the 8106 Server
Connecting the system cables
To mount the breakout box, follow these steps:
Step 1
Locate the breakout box shipped with the system.
Step 2
Locate the screws shipped with the system for mounting the breakout box.
Step 3
Use a screwdriver to mount the breakout box into the position directly above the MeetingPlace server in
the rack as in
the rack as in
Figure 3-7
Mounting the Breakout Box
Connecting the system cables
This section describes how to connect the system cables correctly.
Connecting the power cable
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning
When installing or replacing the unit, the ground connection must always be made first and
disconnected last. Statement 1046
disconnected last. Statement 1046
To connect the power cable to the 8106 server, perform the following steps:
Step 1
Locate the power cable that is shipped with your unit.
Step 2
Attach the socket end of this power cable to the AC inlet on the back of the 8106 server. See
.
Step 3
Plug the other end of this power cable into the AC power source.