Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
3-19
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 3 Installing the 8106 Server
Connecting the system cables
MeetingPlace servers for E1 and T1 PRI configurations are also shipped with a breakout box and cables.
The breakout box provides a standard RJ-45 telephony interface for E1 and T1 PRI systems. Also
shipped are the necessary number of trunk card interface cable assemblies (50-pin Amphenol cables).
These connect the breakout box to the Multi Access Blade transition modules.
The breakout box provides a standard RJ-45 telephony interface for E1 and T1 PRI systems. Also
shipped are the necessary number of trunk card interface cable assemblies (50-pin Amphenol cables).
These connect the breakout box to the Multi Access Blade transition modules.
shows the
50-pin Amphenol cable.
The number of E1 or T1 PRI telephony cables shipped with the system depends on the number of ports
being activated. You need one E1 telephony cable for every 30 ports in an E1 system and one T1 PRI
telephony cable for every 23 ports in a T1 PRI system.
being activated. You need one E1 telephony cable for every 30 ports in an E1 system and one T1 PRI
telephony cable for every 23 ports in a T1 PRI system.
Looking at the back of the server, the Multi Access Blade transition modules begin in slot 1 on the
bottom and move up to slot 6 at the top. The Smart Blades begin after the last Multi Access Blade and
do not have any cables connected to them.
bottom and move up to slot 6 at the top. The Smart Blades begin after the last Multi Access Blade and
do not have any cables connected to them.
Figure 3-11 50-pin Amphenol Cable
breakout box services one MA-16 with 16 spans, one MA-4 with four spans, or two MA-4s with four
spans each.
spans each.